Update desktop-login.rst (#483)

Author: jans23

source/components/nitrokeys/features/u2f/desktop-login.rst

@@ -147,7 +147,7 @@ CLI Method
 
       $ pamu2fcfg > ~/.config/Nitrokey/u2f_keys
 
-   Once you run the command above, you will need to touch the key while it flashes. Once done, ``pamu2fcfg`` will append its output the ``u2f_keys`` in the following format:
+   Once you run the command above, you will need to touch the device while it flashes. Once done, ``pamu2fcfg`` will append its output the ``u2f_keys`` in the following format:
 
    .. code-block:: bash
 

source/components/nitropad-nitropc/heads/firmware-update.rst

@@ -129,6 +129,6 @@ Further steps
 ~~~~~~~~~~~~~
 
 .. hint::
-	There is a known issue with the NV41 that it can get stuck after the update in the boot splash(heads takes longer then 30s to get up). This solves it self after max 5 restarts (pressing the power button short). If not please contact support@nitrokey.com 
+	There is a known issue with the NV41 that it can get stuck after the update in the boot splash(heads takes longer then 30s to get up). This solves it self after max 5 restarts (pressing the power button short). If not please `contact <https://www.nitrokey.com/contact>`_ our technical support.
 
 1. In case ``ERROR: TOTP Generation Failed!`` screen will show up, please follow the instructions for Factory Reset (on the left side menu), starting from step

source/components/software/nitropy/all-platforms/test.rst

@@ -5,7 +5,7 @@ This guide describes how to test the Nitrokey 3.
 
 1. Make sure you have the latest `pynitrokey` version installed, please check the `installation instructions`_ for your OS.
 2. Run ``nitropy nk3 test`` this will launch several tests over your key.
-3. During the test, when asked touch the key.
+3. During the test, when asked touch the device.
 
 This is an example of a working key::