Have to reload integration every time I update Home Assistant?

[simondsmason]

I have noticed for some time now that the integration fails to load when I update Home Assistant. I have a heartbeat routine going back and forth between Hubitat and Home Assistant using devices that I turn on and off. It usually complains after I have run an update on Home Assistant. So I go check and sure enough the integration has failed to load. I click Reload and all is fine.

I tried restating Home Assistant without running an update and the integration loads fine. So it appears to be only when running updates. I don't have any updates pending right now so will have to wait until I can confirm this.

I was wondering if this is a timing thing? Perhaps need to load the startup of the integration? Any suggestions? Thanks.

[jason0x43]

Interesting, I haven’t heard of that happening before. How are you running Home Assistant? (HA OS, Docker, etc.) Have you checked HA’s log after an update to see if any errors from the integration show up? That might point to the issue.

[simondsmason]

I think this might be my bad. I am thinking that I routinely run all updates at the same time. So if running a Hubitat update at the same time as Home Assistant then the integration is not going to be able to connect to Hubitat when Home Assistant reloads. So it may be a timing issue. Sorry for the noise. Thanks for providing this integration.